This is a flywithlua script made for easy engine switching in the FF320. No more having 4 copies of the same aircraft!
Instructions are contained in the download. It is IMPERATIVE that you read the document for proper installation.
FF320 engine switcher so 1 acf can hold all 4 carda mods + satcom! No more having 4 copies of the FF320! Instructions are contained in the download. It is IMPERATIVE that you read the document for proper installation. ...
This is a flywithlua script made for easy engine switching in the FF320. No more having 4 copies of the same aircraft!
Instructions are contained in the download. It is IMPERATIVE that you read the document for proper installation.
1.0
10.08 MB
264
Initial File Release
Tilladelse til at uploade
Du må under ingen omstændigheder uploade denne fil til andre websteder.
Tilladelse til ændring
Du må under ingen omstændigheder ændre eller forbedre min fil.
Tilladelse til omdannelse
Du må under ingen omstændigheder konvertere denne fil.
Tilladelse til brug af aktiver
Du må under ingen omstændigheder bruge aktiver fra min fil.
© Mathster - All rights reserved. Enhver genindlæsning eller videredistribution af denne fil uden forudgående skriftligt samtykke fra forfatteren er forbudt. Denne Flight Simulator 2020 Mod blev skabt af Mathster and shared in Aircraft » Aircraft Enhancements til X-Plane 12.
Den første udgave af denne fil er netop lanceret. Velkommen om bord!
Har du spørgsmål? Find din løsning her.
Der er ret tomt herovre.
Der er ret tomt herovre.
Disse brugere har doneret til Mathster for at han fortsat kan lave fantastiske tilføjelser, som alle kan få glæde af.
These add-ons may be required or recommended to use.
Der er ret tomt herovre.
KevinPiller
Installed everyting but when loading in the Lua does not show up and when I exit X Plane I go to the Lua folder and see the script file is in quarantine
Mathster 4 month(s) ago
Make sure you use the Xp11 version of the script if you are on xp11
thommy24dd
IAE engines stay always for me 😞
Mathster 9 month(s) ago
Make sure the kill datarefs are set correctly in the acf
thommy24dd 9 month(s) ago
I checked it several times and do not see any difference
https://i.gyazo.com/8135c0bfe76cf0f408c17a524a04647f.png
https://i.gyazo.com/5bc8b20e8fb4d6f1f42b54cc7872d723.png
https://i.gyazo.com/7c7f99b489eb94cc9d9d20929e09a2ac.png
https://i.gyazo.com/f6466fe924846dbd90dfe374eb325658.png
Mathster 9 month(s) ago
Is there a space at the beginning or at the end of the dataref?
thommy24dd 9 month(s) ago
usualy not but I will double check it
thommy24dd 9 month(s) ago
finaly it must have been something like this. I have been copying the entries from the Tutorial into an empty notecard and noticed there have been "new lines" in addition, not visible at Planemaker. I got it working in the end. Thank you very much!
Mathster 9 month(s) ago
Great that you got it sorted